Let’s just start by saying that I’m not a florist. So if I can create a beautiful Christmas centrepiece using some pine branches and a few flowers and pinecones, so can you. This stunning centrepiece will take less than an hour to create and can be easily adapted to suit your colour scheme for Christmas. As I was going with a pink and peach theme for my décor, I decided to use similar coloured flowers and berries but this would look just as gorgeous using deep winter berries, sprigs of eucalyptus and dark red roses.

 

Here's what you'll need...

  • A few cut pine branches
  • 4 large white chrysanthemums
  • 4 peach roses
  • 2 stems hypericum (St John’s Wort)
  • Pinecones
  • A single-tier cake stand
  • 1 church candle
  • Floral wreath foam ring with plastic base
  • Floral wire

Christmas centrepiece materials

 

Email this article

You can choose to receive this article by email, or print the page now

Christmas Centrepiece final 1

Christmas Centrepiece final 3

 

Here's how it's done...

  • 1

    Immerse the floral foam in water until the bubbles stop forming and it floats to the top (normally 30 seconds to a couple of minutes)

    Christmas centrepiece Step 1

  • 2

    Set the foam on the cake stand

    Christmas centrepiece Step 2

  • 3

    Begin by cutting small pieces from your pine branches so that each stem is between 3-6” long.

    Christmas centrepiece Step 3

  • 4

    Remove the needles just from the base so it’s easier to insert in the foam.

    Christmas centrepiece Step 4

  • 5

    Start inserting the stems into the wreath starting from the edge of the wreath. You want to insert each stem at a 45-degree angle to the wreath so that as you insert them, they begin to wrap and cover the base of the wreath.

    Christmas centrepiece Step 5

  • 6

    Continue doing this all the way until the bottom is fully covered.

    Christmas centrepiece Step 6

  • 7

    Then begin using the pine stems to fill in the top of the wreath. Keep them relatively short and again, angle them slightly so they are facing away from the middle of the wreath.

    Christmas centrepiece Step 7

  • 8

    Once you are satisfied that the base is about 70% covered, cut the stems of your chrysanthemums to about 1-2” long and insert them at various spots around the wreath. Do the same with the roses followed by the hypericum.

    Christmas centrepiece Step 8

  • 9

    For the pinecones, wrap a long piece of wire to the bottom of the stem and twist to form a spike. Use the spike to secure the pinecone to the foam.

    Christmas centrepiece Step 9

  • 10

    Remember to turn the cake stand as you go to ensure the foam is not visible from any side and the flowers and accents are nicely dispersed throughout.

    Christmas centrepiece Step 10

  • 11

    It’s quite simple to remove and replace the pieces if you aren’t immediately happy with them – a little trial and error goes a long way here.

    Christmas centrepiece Step 11

  • 12

    Place your candle in the centre and fill in any empty spots with a few more sprigs of pine.

    Christmas centrepiece Step 12

  • 13

    That’s it! You can now place the candle on your Christmas table and light. Remember to never leave any candles unattended and don’t let your candle burn down too far!

    Christmas Centrepiece final 2

 

By Kimberly Duran on 19.12.16

Guest Contributor

2 responses to “How to Create a Christmas Centrepiece”

  1. […] created this for AO Life and when I volunteered the idea to them, I have to admit, I was a little nervous. Having never […]

  2. […] How to Create a Christmas Centrepiece (AO Life) […]

Leave a Reply