NEFF N30 D64MAC1X0B 60 cm Integrated Cooker Hood - Silver - B Rated

Overall the extractor is good. It does a great job of removing cooking smells, smoke, and vaporised grease from the hob below - no smell at all escapes to the rest of the house - and despite a relatively long vent run in our install, it pushes the air along admirably. The biggest downside is that it's quite noisy - I think some of this is the hard-edged transitions on the vent hose adapter causing unnecessary turbulence in the hose, but the motor is also pretty loud. Given the volume of air it moves some of this is unavoidable, of course, and I expect it'd be better if it were vented directly out the back through a hole in the wall. The other things are minor annoyances rather than real problems: - The installation to a wall was a bit of a pain. The wall plugs are a bit oversized and really needed an 8.5mm hole, not the 8mm they specified. There's a few places (adjusting the level on the wall-mounting hooks, and installing the lower two wall-mounting screws) where the unit itself gets in the way of anything other than a stubby screwdriver or a flexible shaft. The upside here is that the wall-mounting kit is massive overkill - it could support an extractor ten times the weight of this one. Our previous extractor was held in by four screws each side into the adjacent cabinets, this is practically welded to the wall in comparison. (Don't get me wrong, the install is still easily within reach of a normal DIYer. The unit plugs into a regular socket so in most cases you won't need an electrician.) - The controls are mounted in the middle of a sheet-metal panel, which flexes slightly when you press the buttons. It's not a real problem, it just doesn't feel as high-quality and robust as other Neff equipment we have and it could easily have been fixed with a supporting bar across the panel on the inside. - I can understand the unit not allowing the extractor to be turned on unless the hood is open, but there's no reason the light couldn't still be operated; it's a bit annoying that the light is on the same interlock circuit as the extractor so we have to pull the hood open if we just want to use it for a bit of extra illumination.

Excellent

The fan was a straight forward swap for an existing fan of the same dimensions. The fan is good quality and works very well and is very powerful. In fact it is so powerful it is too noisy, even at the lowest setting. For our household the less powerful model would have done.

I could not be more pleased with this cooker hood. It replaces one I purchased three or four years ago, which proved to be most unsatisfactory. A friend recommended this NEFF hood. It is well designed, robust and has proved itself to be very very efficient. The fan has three speeds and so far the lowest speed has shown itself to be more than capable of removing all the steam generated with our cooking. My thanks to ao and to Neff. Best regards, David

Excellent extractor, went for the larger rate of extraction of air. Very good.

My previous NEFF cooker hood worked faultlessly for 30 years. I only replaced it , with another NEFF, because after 30 years it was disgustingly internally covered in grease. Hugely disappointingly, the nowadays relocated lights and fan settings switch panel at the front, held in only by a ludicrously flimsy couple of plastic clips, was already loose on opening the packaging, and the two clips broke immediately on trying to return it to its slot ! I repaired this stupidly under-engineered switch component with some silicon sealant and TWO SCREWS ! It then worked OK. Why didn't it have those two simple screws, or a much more sturdy clip, originally ?The hood now works fine, with good extraction, but my faith in NEFF as a quality brand is destroyed. How long will this one function ? not as long as its predecessor I'd bet . Do not buy this flimsy cooker hood - unless you are as handy as me with the repair of badly designed , laughably over-flimsy, components