Customer Reviews — NEFF N50 D64BHM1N0B 60 cm Chimney Cooker Hood - Stainless Steel - B Rated

Customer Reviews — NEFF N50 D64BHM1N0B 60 cm Chimney Cooker Hood - Stainless Steel - B Rated

NEFF N50 D64BHM1N0B 60 cm Chimney Cooker Hood - Stainless Steel - B Rated
£419
  • Suitable for use above a standard-sized hob
  • Quickly clears the air in a small kitchen
  • Easy-to-use touch controls
  • Easy to clean thanks to the washable grease filter
  • Dimensions (cm) H63.5 x W60 x D50 - Learn more
4.8 / 5
14
4
0
0
0

Would recommend

5/5
Perfect.
Adam

Stylish & modern

5/5
Stylish, modern product. Not yet installed as new kitchen being installed, but have seen this model in use and its quiet compared to my old unit and easy to use
Isogen

Quality item

4/5
Considered buying a cheaper item off eBay but then opted for this as it matches the oven/hob etc. Quality looks premium unfortunately I can’t comment on performance as it isn’t installed yet.
Ian D

PLEASED WITH PRODUCT & SERVICE

5/5
Excellent product. Exactly what we had hoped for and does what it says on the box. No complaints whatever.
Hector Nicolson

great product

5/5
great looking and build quality very good
nigel

Great purchase

5/5
Great product , really pleased with the purchase .
Gary

Disappointing details

4/5
The product itself seems very good (only a week old) and the noise level is much lower than our previous model. The big but comes with the fitting. I am no stranger to diy work but this was a challenge. Firstly the bracket holding the top of the flue is cranked forwards about 25mm and unless the outlet pipe is hard against the wall it won't fit. Also the wall plug/screw combination was much too tight resulting in the plugs turning with the screws and unable to screw in further or take them out. I wish I'd used my own plugs and screws.
Shropshire Bob

Super powerful cooker hood

5/5
Overall a fantastic item . Easy enough to install, but I don’t understand why you would make the gap for the fixing holes 200mm for the hood and 210mm for the chimney, if they were both the same you could simply use a level to mark up. Once installed a very powerful extractor which is relatively quite. Fully recommended.
Andy
1 2 3